google chromecast setup cisco wireless lan controller

#Google chromecast setup cisco wireless lan controller series#
#Google chromecast setup cisco wireless lan controller mac#

#Google chromecast setup cisco wireless lan controller mac#

Override-This option allows the access point to operate in high-power mode without first verifying a matching MAC address. This option to cause the new MAC address to be remembered. You must then physically verify the existence of a power injector and reselect Want the access point to find the switch MAC address, leave the Injector Switch MAC Address text box blank.Įach time an access point is relocated, the MAC address of the new switch port fails to match the remembered MAC address,Īnd the access point remains in low-power mode. If you want to configure the switch MAC address, enter the MAC address in the Injector Switch MAC Address text box.

Choose this option if your network contains older Cisco 6-Watt switches and you want to avoid possible overloadsīy forcing a double-check of any relocated access points. Installed-This option examines and remembers the MAC address of the currently connected switch port and assumes that a power injector Choose one of these options from the drop-down list to specify the Overload if the power injector is inadvertently bypassed. The Power Injector Selection parameter enables you to protect your switch port from an accidental If you selected the Power Injector State check box in the previous step, the Power Injector Selection and Injector Switch IPM, you do not need to select this check box. This is the default value.Ĭheck the Power Injector State check box if the attached switch does not support IPM and a power injector is being used.

Uncheck the Pre-standard 802.3af switches check box if power is being provided by a power injector.

This switch provides more than the traditionalĦ Watts of power but do not support the intelligent power management (IPM) feature.

Check the Pre-standard 802.3af switches check box if the access point is being powered by a high-power 802.3af Cisco switch.

Second, the “PoE Status: degraded operation” message appears in the controller’s trap log on the Trap Logs page. Message appears under the Tx Power Level Assignment section on the 802.11a/n /ac (or 802.11b/g/n) Cisco APs > Configure page. First, the “Due to low PoE, radio is transmitting at degraded power” If the access point is operating at a lower power level.

#Google chromecast setup cisco wireless lan controller series#

This text box applies only to 1250 series access points that are powered using PoE. The controller auto-detects the access point’s power source and displays the power level The PoE Status text box shows the power level at which the access point is operating: High (20 W), Medium (16.8 W), or Medium (15.4 W). This section contains the following subsections:Ĭonfiguring Power over Ethernet (GUI) ProcedureĬhoose Wireless > Access Points > All APs and then the name of the desired access point.Ĭhoose the Advanced tab to open the All APs > Details for (Advanced) page. Client Traffic Forwarding Configurations.Connecting Mesh Access Points to the Network.